approval test
英 [əˈpruːvl test]
美 [əˈpruːvl test]
鉴定试验；合格性检验
双语例句
- Instead, it published a series of prerequisites for future applications seeking approval for any HIV diagnostic test which preemptively forbade rapid home tests.
不仅如此，FDA还出台了一系列条条框框来约束未来任何HIV检测产品的申请，这相当于先发制人地否决了HIV快速家庭自测。 - I hope and expect that TPP when presented for approval will meet this test.
我希望并预计，届时提交审批的TPP将会通过这种考验。 - Thirdly, upon approval of the school, non-English majors of SIB can take part in the TEM-8 ( Test for English Majors).
我院非英语专业学生经学院批准，可参加全国英语专业八级考试（TEM-8）。 - In accordance with handover procedure, document and relevant certificates will be issued for approval from Jiansu LNG at each step of the completion work such as construction completion, pre-commissioning, commissioning, start-up and performance test.
按照移交程序，江苏液化天然气有限公司在工程竣工的每个阶段（工程竣工、预调试、试运车、开车及性能测试）发行文件及相关证书供批准。 - The test procedures that require review or approval will be submitted prior to the start of test.
须在试验开始前提交要求审查或批准的试验程序。 - Some products and has successfully passed the TUV certification, CE certification and type approval test, and through the EU ROHS environmental protection directives.
部分产品并已顺利通过了TUV认证、CE认证和型式认可实验，并通过ROHS欧盟环保指令。 - If specified in the technical specifications, the bidder shall also provide report of type approval test for bidding equipment or similar equipment.
如技术规格书中有要求，投标人也应提供投标设备或类似设备的型式试验报告。 - The carmaker said in separate statements yesterday that it had received approval to test drive the vehicle on Japanese roads, and that it would provide prototypes to two research groups at the University of California.
在昨日两份独立的声明中，丰田表示，该公司已获准在日本路面进行此款汽车的试驾，同时将把这款汽车的样车提供给加州大学（universityofcalifornia）的两个研究团队。 - Simulation Study of Ocean Wave Impact Load for Shipborne Weapon System's Terrestrial Type Approval Test
舰载武器系统陆上定型试验海浪冲击负载仿真研究 - Design of Servo System Loader Simulator in Self-propelled Anti-aircraft Gun Approval Test
自行高炮定型试验随动系统负载仿真器设计 - In case of any interruption during the test without approval by the tenderee, the test shall be redone and any responsibility for factory acceptance delay and cost arising therefrom shall be borne by the bidder.
试验期间，发生未经招标者认可的中断，则试验将重新开始，由此造成的工厂验收时间延长的责任和费用应由投标人承担。 - Final test reports that require review or approval will be submitted following completion of the test.
要求审查或批准的最终试验报告需在试验结束后提交。 - Note: all kinds of transfer paper are subject to approval sample test hot, before mass production.
注意：各种烫画纸都需试烫小样认可后，方可批量生产。 - The clinical research should be conducted according to Rules on New Drug Examination and Approval and Management Standard of the Clinical Test of Drugs ( GCP).
临床研究须按照中国《新药审批办法》及《药品临床试验管理规范》（GCP）的规定执行。 - The design of inner and outer supporter and shelf structure, the measures for ensuring the vacuum and cleanness during fabrication, and the type approval test are described in details.
阐述了内、外容器支撑和框架结构的设计，在制造过程中为保证真空度和清洁度而采取的措施以及型式试验情况； - Gun control subsystem is a key part of the main battle tank, before the type approval test of battle tank, the test for subsystem has to be done.
炮控分系统是主战坦克等地面攻坚武器系统的重要组成部分，在坦克全系统定型试验前，必须进行分系统的试验测试。 - Finally, the article suggests solutions from aspects of project approval, construction of laws and regulations and the test target set in scientific economy.
并分别从项目的审批，法律、法规建设及建立科学的经济测试指标三个方面提出了解决困难的办法。 - Pointing to the second artillery in the national approval test, the test technology by physical model instead of the second artillery was firstly studied.
针对国家靶场定型试验中在副炮上进行的各项试验，首次研究了用模型炮代替副炮的多项目综合物理模拟试验技术。 - It raises the theory that the ethical stipulation of technology is a process and it divides the process into four phases, that is the ethical assessment in design phase, ethical approval in test phase, ethical act in application phase and ethical adjustability in diffusion.
提出技术伦理规约过程性的理论主张，并将技术伦理规约的过程分成四个阶段，即设计阶段的伦理评估，试验阶段的伦理鉴定，应用阶段的伦理立法，推广阶段的伦理调整。 - The method can be applied to the determination of acceptance standards of products and be used for reference in the course of revision of the National Military Standard: 《 Approval Test Regulations of Dispenser Bomblets by Gun 》( GJB 40242000).
该方法可用于确定验收指标，也可以在国军标《炮用子母弹定型试验规程》（GJB4024-2000）修订时作为参考。 - The development of composite gas cylinders, progress of its standard, key technology and the type approval test were introduced.
本文对复合材料气瓶的发展、标准进展情况以及其关键技术和型式试验等问题作了全面介绍。 - The Procedure and Method of Type Approval Test of 4-stroke Engine Motorcycle
四冲程摩托车开发定型试验的流程和方法 - To introduce the design method, composition and main study content of "Aid-decision System of Heavy Machine Gun System of Approval Test".
介绍了重机枪系统定型试验辅助决策系统的设计方法、组成和主要研究内容； - Based on such reasons, this paper designs a test system used to effectively measure the resistivity of the semi-conductive shield in electric type approval test, which is based on Virtual instrument ( for short VI) about the resistivity of the semi-conductive shield.
基于以上原因，本文设计开发一套基于PC的电缆半导电屏蔽电阻率测试系统，用于对成品电缆的电气型式试验中半导电屏蔽电阻率的测量。 - According to the different requirements of routing check and approval test, different demands on indicated power and acceptance specifications are proposed to better meet the requirements of accurate emission tests.
根据检查站日常运行测试和核准测试的不同要求，提出了不同的指示功率要求和技术要求，更好地满足了工况法准确排放测试的需要。 - Research of Approval Test for Gunnery Pod
航炮吊舱定型试验方法初探 - An Analysis of the Design of a Type Approval Test Platform for Hydraulic Pumps
液压泵型式试验台设计分析 - The turn-to-turn insulation test is an approval test for pole coil of large electrical machine.
大电机磁极线圈匝间绝缘试验是为了检验磁极线圈匝间绝缘耐压性的检查性试验。 - Then it introduced the current mainstream standard, which leads to the system involved in the WLAN terminal type approval test items and test methods, test items described in detail and the definition and purpose of the test, manual testing process.
然后介绍了当前主流标准，从而引出本系统涉及的无线局域网终端型号核准测试项目和测试方法，详细介绍了测试项目的定义和测试目的手动测试方案。 - Through the ADOBE online examination and approval system for the development of the perfect the function of ERP, this article elaborated the online examination and approval system in Lanzhou petrochemical ERP project implementation in the demand, development, test and operation process of the approach.
通过ADOBE内控审批系统的开发来完善ERP的功能，本文阐述内控审批系统在兰州石化ERP项目实施中需求、开发、测试运行的具体过程。